John-wood Commercial Storage Tanks 80G - 120G Manuel d'utilisateur télécharger pdf

Hand Hole

Clean Out

Floor Drain

6”

Drain pan

(Piped to Drain

as Illustrated)

Temperature and

Pressure Relief Valve

Connections Valve

1” NPT Relief

Not Provided

Relief Valve

Discharge

Line to

Suitable

Open Drain

Terminate 6”

Above Drain

Anode 119 GAL

Hot Outlet 2 NPT

Anodes 119 GAL & 80 GAL

Aquastat

Connection

3/4 NPT

Circulating

Connections

2 NPT

Drain Valve

3/4 NPT

80G - 120G INSULATED STORAGE TANK

INSTALLATION AND OPERATING INSTRUCTIONS

Read these instructions

thoroughly before starting

Please retain these instructions in

a safe location for future reference.

NOTE: These instructions apply only to

this storage tank unit. The water

heating source or other

components of the system

should be installed in

accordance with their

instructions, provided by their

manufacturer.

FOR YOUR SAFETY:

*Do not store or use gasoline or other

flammable vapours or liquids in the vicinity

of this or any other appliance.

*Installation and service must be

performed by a qualified installer, service

agency, gas supplier, or electric utility.

WARNING: Improper installation,

adjustment, alteration, service, or

maintenance can cause injury or property

damage. Refer to this manual. For

assistance or additional information,

consult a qualified installer, service

agency, gas/oil supplier, or the electric

utility.

WARNING: If the information in these

instructions is not followed exactly, a fire,

explosion, or water damage may result

causing property damage, personal injury

or death.

MEETS OR EXCEEDS ASHRAE 90.1b 1999.

IMPORTANT CONSUMER NOTICE

These instructions have been written for the proper

installation, safe operation and maintenance of this storage

tank unit.

It is your responsibility to ensure that your insulated storage

tank is properly installed and cared for. FAILURE TO

FOLLOW THE INSTRUCTIONS IN THIS MANUAL MAY

RESULT IN SERIOUS BODILY INJURY AND/OR

PROPERTY DAMAGE. THOROUGHLY READ ALL

INSTRUCTIONS BEFORE YOU ATTEMPT TO INSTALL

OR OPERATE THIS UNIT.

Installation and service require trade knowledge in the area

of plumbing, electricity, venting, air supply, and gas supply.

Installation is required by a qualified tradesperson in

accordance with National/Local Codes.

The manufacturer of this insulated storage tank cannot be

held liable for those damages caused by improper

installation, sizing, or failure to comply with these

instructions. PROTECT YOUR WARRANTY: Regularly

maintain your unit as detailed in the service and

maintenance section of this manual.

PART NO. 71768 REV. A (05-03)

FIGURE 1.

PART NO. 62607 REV. A (03-08)

1 2 3 4

Résumé du contenu

Page 1 - Improper installation

Hand HoleClean OutFloor Drain6”Drain pan(Piped to Drainas Illustrated)Temperature andPressure Relief ValveConnections Valve1” NPT ReliefNot ProvidedRe

Page 2

CANADIAN INSTALLATIONSIn addition to the installation instructions found in this manual, the heater shall be installed in accordance with the latest e

Page 3 - INSTALLATION INSTRUCTIONS

Locate the storage tank in a clean and dry area close to the water heating source and preferably central to the piping system (this is to help prevent

Page 4 - SERVICE AND MAINTENANCE

TYPICAL PLUMBING APPLICATIONSHOTOUTLETAQUASTATSHUTOFFVALVEHCBOILERTANKLESSCOILBRONZECIRCULATORCOLDINLETHOTOUTLETHOTOUTLETHOTOUTLETHOTOUTLETHOTOUTLETHO

Commentaires sur ces manuels

Pas de commentaire

John-wood Commercial Storage Tanks 80G - 120G Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Chaudière à eau John-wood Commercial Storage Tanks 80G - 120G. John Wood Commercial Storage Tanks 80G - 120G User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Chaudière à eau John-wood Commercial Storage Tanks 80G - 120G